Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › DRIVE BELT › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211283 DRIVE BELT G

2WW ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT FAN AND GENERATOR V BELT

a.
B000543

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
B075171C05
0.573,1.354 0.885,1.51 0.313,0.156 10 *a 2.271,1.375 2.583,1.531 0.313,0.156 10 *b
*a Correct
*b Incorrect


Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



Hide 2.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

a.
A354297

Turn the V-ribbed belt tensioner assembly clockwise and counterclockwise and check that it turns smoothly and does not catch.

If a malfunction exists, replace the V-ribbed belt tensioner assembly.