13711
1.REMOVE INTAKE VALVE
Arrange the intake valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order.
Place the cylinder head sub-assembly on a wooden block.
| *a | Wooden Block |
Using SST, compress the 4 inner compression springs and remove the 8 valve spring retainer locks.
Remove the 4 valve spring retainers, 4 inner compression springs and 4 intake valves.
13715
2.REMOVE EXHAUST VALVE
Arrange the exhaust valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order.
Place the cylinder head sub-assembly on a wooden block.
| *a | Wooden Block |
Using SST, compress the 4 inner compression springs and remove the 8 valve spring retainer locks.
Remove the 4 valve spring retainers, 4 inner compression springs and 4 exhaust valves.
13711A
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the 8 valve stem oil seals.
4.REMOVE STUD BOLT
If a stud bolt is deformed or the threads are damaged, replace it.
Remove the 8 stud bolts.