Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › CYLINDER HEAD › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211290 CYLINDER HEAD A

2WW ENGINE MECHANICAL  CYLINDER HEAD  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL STUD BOLT

HINT:

If a stud bolt is deformed or the threads are damaged, replace it.


a.

Install the 8 stud bolts.

HINT:

Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.



Hide 13711A 2.INSTALL VALVE STEM OIL SEAL

a.

Apply a light coat of engine oil to a new valve stem oil seal.


b.
A318619N01
1.646,0.458 1.917,0.167 1.917,0.167 2.083,0.167 false 2.146,0.094 2.604,0.292 0.458,0.198 10 false SST

Using SST, push in the 8 valve stem oil seals.

SST:

PZ4TB-04932-49



Hide 13711 3.INSTALL INTAKE VALVE

a.

Place the cylinder head sub-assembly on a wooden block.


b.

Install the 4 intake valves, 4 inner compression springs and 4 valve spring retainers to the cylinder head sub-assembly.

NOTICE:

Install the same parts in the same combination to their original locations.



c.
A318415N01
1.906,0.51 1.833,0.167 1.833,0.167 1.667,0.167 false 1.333,0.094 1.792,0.292 0.458,0.198 10 false SST

Using SST, compress the inner compression spring and place the 8 valve spring retainer locks around the intake valve stem.

SST
09202-70020  
09202-00021  


d.

Using a 5 mm pin punch and plastic-faced hammer, lightly tap the intake valve stem tip to ensure a proper fit.

NOTICE:

Be careful not to damage the intake valve stem tip.



Hide 13715 4.INSTALL EXHAUST VALVE

a.

Place the cylinder head sub-assembly on a wooden block.


b.

Install the 4 exhaust valves, 4 inner compression springs and 4 valve spring retainers to the cylinder head sub-assembly.

NOTICE:

Install the same parts in the same combination to their original locations.



c.
A318414N01
1.083,0.417 1.25,0.167 1.25,0.167 1.417,0.167 false 1.5,0.083 1.958,0.281 0.458,0.198 10 false SST

Using SST, compress the inner compression spring and place the 8 valve spring retainer locks around the exhaust valve stem.

SST
09202-70020  
09202-00021  


d.

Using a 5 mm pin punch and plastic-faced hammer, lightly tap the exhaust valve stem tip to ensure a proper fit.

NOTICE:

Be careful not to damage the exhaust valve stem tip.