13711
1.REPAIR INTAKE VALVE SEAT
Repair the seat while checking the seating position.
Release the cutter gradually to make the valve seat smooth.
| *a | Width |
If the seating is too high on the intake valve face, use 45° and 15° cutters to correct the intake valve seat.
| *a | Width |
If the seating is too low on the intake valve face, use 72° and 45° cutters to correct the intake valve seat.
Check that the intake valve seat contacts in the middle of the intake valve face and has the following width.
1.2 mm (0.0472 in.)
13715
2.REPAIR EXHAUST VALVE SEAT
Repair the seat while checking the seating position.
Release the cutter gradually to make the valve seat smooth.
| *a | Width |
If the seating is too high on the exhaust valve face, use 45° and 15° cutters to correct the exhaust valve seat.
| *a | Width |
If the seating is too low on the exhaust valve face, use 60° and 45° cutters to correct the exhaust valve seat.
Check that the exhaust valve seat contacts in the middle of the exhaust valve face and has the following width.
1.4 mm (0.0551 in.)