When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) is memorized, so be sure to make a note of the automatic open stop position.
67939B
1.REMOVE BACK DOOR CENTER GARNISH
67938A
2.REMOVE BACK DOOR SIDE GARNISH LH
67937B
3.REMOVE BACK DOOR SIDE GARNISH RH
Use the same procedure described for the LH side.
67750
4.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
89222A
5.REMOVE MULTIPLEX NETWORK DOOR ECU
|
Bolt |
|
Connector |
Disconnect the 2 connectors.
Remove the 2 bolts.
Detach the clip and guide and remove the multiplex network door ECU.