Home › Drivetrain › K114 MULTIDRIVE / CVT › PARK / NEUTRAL POSITION SWITCH › from 2015.10
RM3090E _52 Drivetrain _044380 K114 MULTIDRIVE / CVT _0212488 PARK / NEUTRAL POSITION SWITCH A

K114 MULTIDRIVE / CVT  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Temporarily install the park/neutral position switch assembly to the continuously variable transaxle assembly with the 2 bolts.


b.
C296024

Install the lock plate and lock nut to the park/neutral position switch assembly.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


c.

Temporarily install the control shaft lever to the park/neutral position switch assembly.


d.
C296025C01
3.094,1.042 3.375,1.281 0.281,0.24 10 true *a 2.865,0.51 3.146,0.75 0.281,0.24 10 true *b
*a P Position
*b N Position


Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.


e.

Remove the control shaft lever from the park/neutral position switch assembly.


f.
C296028C02
1.719,1.042 2.385,1.042 true 1.708,1.469 2.615,1.469 true 2.667,1.396 2.979,1.594 0.313,0.198 10 true *b 2.438,0.969 2.75,1.167 0.313,0.198 10 true *a
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


g.

Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


h.
C296029

Using a screwdriver, stake the lock nut with the lock plate.


i.

Install the control shaft lever to the park/neutral position switch assembly with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


j.

Connect the park/neutral position switch assembly connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.


b.
C296025C01
3.094,1.042 3.375,1.281 0.281,0.24 10 true *a 2.865,0.51 3.146,0.75 0.281,0.24 10 true *b
*a P Position
*b N Position


Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.


c.

Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

Hide 84540 6.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER