Home › Power Source / Network › 2WW BATTERY / CHARGING › GENERATOR › from 2015.10
RM3090E _57 Power Source / Network _044381 2WW BATTERY / CHARGING _0212676 GENERATOR A

2WW BATTERY / CHARGING  GENERATOR  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL GENERATOR REGULATOR ASSEMBLY

a.
A320043C01
0.865,0.438 1.5,0.167 1.5,0.167 1.583,0.167 true 0.5,1.5 0.583,1.5 0.583,1.5 0.833,1.115 true 1.646,0.094 1.958,0.25 0.313,0.156 10 false *a 0.323,1.406 0.635,1.563 0.313,0.156 10 false *b
*a Brush
*b Brush Cap


Push in the brushes and slid the brush cap to hold the brushes in place.


b.
A316704C01
0.583,0.25 0.667,0.25 0.667,0.25 1.5,0.74 true 0.406,0.167 0.719,0.323 0.313,0.156 10 false *a
*a Brush Cap


Install the generator regulator assembly with the 3 bolts.

Torque:
4.3 N*m (44 kgf*cm, 38 in.*lbf)


c.

Push in the brush cap.

HINT:

By pushing in the brush cap after installing the generator regulator assembly, the brushes pop out and contact the slip rings.



d.

Install the generator rear end cover with the bolt and nut.

Torque:
3.9 N*m (40 kgf*cm, 35 in.*lbf)