Home › Engine / Hybrid System › 2WW STARTING › ENGINE SWITCH › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219542 ENGINE SWITCH G

2WW STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.
A295732C09
0.76,0.906 1.208,1.073 true 2.208,1.083 2.688,0.927 true 2.219,1.344 2.698,1.573 true 1.146,1.906 1.521,1.427 true 0.052,0.042 0.365,0.198 0.313,0.156 10 *a 0.458,0.823 0.917,1.021 0.458,0.198 10 SS1 2.75,0.854 3.208,1.052 0.458,0.198 10 SS2 2.781,1.531 3.396,1.729 0.615,0.198 10 AGND 0.938,1.927 1.365,2.125 0.427,0.198 10 SWIL
*a Component without harness connected
(Engine Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (SS1) - 6 (AGND)
1 (SS2) - 6 (AGND)
Not pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the engine switch.


b.

Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch indicator light.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


HINT:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

·

If the voltage is too low, the engine switch indicator light will not illuminate.



If the result is not as specified, replace the engine switch.