Home › General › SPECIFICATIONS › 2WW STARTING › from 2015.10
RM3090E _V1 General _009232 SPECIFICATIONS _0208139 2WW STARTING F

SPECIFICATIONS  2WW STARTING  SERVICE DATA  


Glow plug assembly
Tester Connection Condition Specified Condition
Glow plug assembly terminal - Glow plug assembly body 20°C (68°F) 0.1 to 0.9 Ω

Starter assembly
Tester Connection Condition Specified Condition
Battery positive (+) terminal - Terminal 30 - Terminal 50 11 V Below 70 A

Repair service starter kit
Tester Connection Condition Specified Condition
Terminal 50 - Terminal C Always Below 1 Ω
Terminal 50 -Magnet switch body Below 2 Ω

Starter armature assembly
Tester Connection Condition Specified Condition
Segment - Segment Always 2.67 to 3.29 Ω
Segment - Starter armature core 10 kΩ or higher

Commutator for runout Standard Runout 0.05 mm (0.00197 in.)
Maximum Runout 0.07 mm (0.00276 in.)

Commutator diameter Standard Diameter 30.2 mm (1.19 in.)
Minimum Diameter 28.9 mm (1.14 in.)

Undercut depth Standard Undercut Depth 1.43 mm (0.0563 in.)
Minimum Undercut Depth 0.75 mm (0.0295 in.)

Starter brush holder assembly
Brush length Standard Length 12.3 mm (0.484 in.)
Minimum Length 9.8 mm (0.386 in.)

Tester Connection Condition Specified Condition
A - B
A - C
B - D
C - D
Always 10 kΩ or higher
A - D
B - C
Below 1 Ω

Engine switch
Tester Connection Condition Specified Condition
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND)
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND)

Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates

Ignition or starter switch assembly
Tester Connection Condition Specified Condition
Between all terminals LOCK 1 MΩ or higher
5 (AM1) - 7 (ACC) ACC Below 1 Ω
5 (AM1) - 7 (ACC) - 8 (IG1) ON Below 1 Ω
3 (IG2) - 4 (AM2)
5 (AM1) - 6 (ST1) - 8 (IG1) START Below 1 Ω
2 (ST2) - 3 (IG2) - 4 (AM2)

Ignition or starter switch assembly
Tester Connection Condition Specified Condition
Between all terminals LOCK 1 MΩ or higher
5 (AM1) - 7 (ACC) ACC Below 1 Ω
5 (AM1) - 7 (ACC) - 8 (IG1) ON Below 1 Ω
3 (IG2) - 4 (AM2)
5 (AM1) - 6 (ST1) - 8 (IG1) START Below 1 Ω
2 (ST2) - 3 (IG2) - 4 (AM2)

ST relay
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω