Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › SFI SYSTEM(except K111, K111F) › from 2015.10
RM3090E _51 Engine / Hybrid System _008380 3ZR-FE ENGINE CONTROL _0219904 SFI SYSTEM(except K111, K111F) D

3ZR-FE ENGINE CONTROL  SFI SYSTEM(except K111, K111F)  FREEZE FRAME DATA  


DESCRIPTION


The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

HINT:

If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.



A103809E77
2.281,0.094 3.156,0.26 0.875,0.167 10 DTC stored 1.281,0.969 2.063,1.146 0.781,0.177 10 0.5 seconds 0.375,0.99 1.156,1.188 0.781,0.198 10 0.5 seconds 0.354,2.771 2.688,2.927 2.333,0.156 10 Freeze frame data which can be read 2.198,0.969 2.979,1.167 0.781,0.198 10 0.5 seconds

The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

·

3 data sets before the DTC was stored.

·

1 data set when the DTC was stored.

·

1 data set after the DTC was stored.


These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.




PENDING FREEZE FRAME DATA


HINT:

Pending freeze frame data is stored when a 2 trip DTC is first detected during the first trip.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Select a DTC in order to display its pending freeze frame data.

HINT:
·

Pending freeze frame data is cleared when any of the following occurs.

·

The DTCs are cleared using the GTS.


·

The cable is disconnected from the negative (-) battery terminal.


·

40 trips with the engine fully warmed up have been performed after returning to normal. (Pending freeze frame data will not be cleared by only returning the system to normal.)


·

With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new data of the newly detected DTC in the next trip.



A251781E15
0.156,0.104 6.771,0.635 6.615,0.531 10 When a DTC is detected in both the first and second trips but the system returns to normal from the third trip (2 trip logic DTC): 0.146,1.625 1.24,1.802 1.094,0.177 10 Ignition Switch 1.302,1.458 2.115,1.75 0.813,0.292 10 ON 1.302,1.844 1.552,2.021 0.25,0.177 10 Off 0.156,2.583 1.198,2.896 1.042,0.313 10 Pending Freeze Frame Data 1.333,2.5 1.781,2.698 0.448,0.198 10 Stored 1.323,2.781 1.771,3.125 0.448,0.344 10 Not Stored 0.125,3.708 1.042,4.406 0.917,0.698 10 Freeze Frame Data 1.292,3.667 1.74,3.865 0.448,0.198 10 Stored 0.365,4.698 1.938,4.927 1.573,0.229 10 : Malfunction detected 0.365,5.021 2.083,5.229 1.719,0.208 10 : Malfunction not detected 2.073,0.885 2.76,1.094 0.688,0.208 10 (First Trip) 2.823,0.885 3.781,1.125 0.958,0.24 10 (Second Trip) 3.781,0.885 4.74,1.125 0.958,0.24 10 (Third Trip) 4.594,0.896 5.552,1.135 0.958,0.24 10 (Fourth Trip) 1.302,3.938 1.74,4.292 0.438,0.354 10 Not Stored

A251782E17
0.188,0.177 7.063,0.594 6.875,0.417 10 When 2 trip DTC is first detected in the first trip and another 2 trip DTC is first detected in the second trip: 0.479,1.531 1.396,1.844 0.917,0.313 10 Ignition Switch 1.781,1.365 2.302,1.583 0.521,0.219 10 ON 1.781,1.719 2.125,1.896 0.344,0.177 10 Off 0.479,2.323 1.542,2.688 1.063,0.365 10 Pending Freeze Frame Data A 0.479,3.271 1.479,3.667 1,0.396 10 Pending Freeze Frame Data B 1.781,2.25 2.24,2.417 0.458,0.167 10 Stored 1.781,3.156 2.24,3.323 0.458,0.167 10 Stored 1.781,2.531 2.208,2.948 0.427,0.417 10 Not Stored 1.781,3.448 2.208,3.865 0.427,0.417 10 Not Stored 0.677,4.146 3.188,4.385 2.51,0.24 10 : Pending malfunction A detected 0.677,4.625 3.188,4.865 2.51,0.24 10 : Pending malfunction B detected 0.677,5.135 2.771,5.365 2.094,0.229 10 : No malfunction detected 4.198,2.875 5.302,3.052 1.104,0.177 10 Uploaded 2.635,0.719 3.333,1.031 0.698,0.313 10 (First Trip) 3.542,0.719 4.677,0.99 1.135,0.271 10 (Second Trip) 4.604,0.719 5.729,1.052 1.125,0.333 10 (Third Trip) 5.521,0.719 6.719,1.052 1.198,0.333 10 (Fourth Trip)



LIST OF FREEZE FRAME DATA


Refer to "Data List / Active Test".

Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(except K111, K111F)>DATA LIST / ACTIVE TEST