Home › Engine / Hybrid System › 2WW LUBRICATION › LUBRICATION SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044378 2WW LUBRICATION _0220671 LUBRICATION SYSTEM G

2WW LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up and stop the engine, then wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.

If the level is low, check for engine oil leaks and add engine oil to the full level mark.

NOTICE:

Do not fill to above the full level mark.


HINT:

A certain amount of engine oil will be consumed while driving. In the following situations, engine oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

·

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

·

If low quality engine oil or oil of an inappropriate viscosity is used.

·

When driving at high engine speeds or with a heavy load (when towing, etc.), or when accelerating or decelerating frequently while driving.

·

When idling for a long time, or when driving frequently through heavy traffic.


When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the engine oil for deterioration, water intrusion, discoloration or thinning.

If the quality is visibly poor, replace the engine oil and oil filter element.


Hide 3.INSPECT OIL PRESSURE

a.

Using a 27 mm socket wrench, remove the oil filter cover.


b.

Remove the oil filter sub-assembly from the oil filter cover.


c.
A318626C01
2.396,0.385 2.781,0.385 false 0.542,0.281 0.844,0.281 0.844,0.281 1.302,1.156 true 2.229,0.281 2.542,0.438 0.313,0.156 10 false *a 0.219,0.177 0.677,0.375 0.458,0.198 10 false SST
*a Oil Pressure Gauge


Set an oil filter sub-assembly in SST.


d.

Using a 27 mm socket wrench, tighten SST.

SST:

PZ4TB-22084-23


Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

After tightening SST, make sure that there is no gap and that the O-ring is not protruding.



e.

Install the oil pressure gauge with SST.


f.

Warm up the engine.


g.

Measure the engine oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idling 180 kPa (1.8 kgf/cm2, 26 psi) or higher
4000 rpm 400 to 420 kPa (4.1 to 4.3 kgf/cm2, 58 to 61 psi)



h.

Remove the oil pressure gauge.


i.

Using a 27 mm socket wrench, remove SST.


j.

Install a new oil filter sub-assembly.

Click hereEngine / Hybrid System>2WW LUBRICATION>OIL AND OIL FILTER>REPLACEMENT