Home › Engine / Hybrid System › 2WW LUBRICATION › OIL PRESSURE SWITCH › from 2015.10
RM3090E _51 Engine / Hybrid System _044378 2WW LUBRICATION _0220673 OIL PRESSURE SWITCH G

2WW LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the engine oil pressure switch assembly connector.


b.

Start the engine.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
Engine stopped Below 1 Ω


If the result is not as specified, replace the engine oil pressure switch assembly.


d.

Connect the engine oil pressure switch assembly connector.