Home › Drivetrain › CLUTCH › CLUTCH UNIT(for 2WW) › from 2015.10
RM3090E _52 Drivetrain _008754 CLUTCH _0220760 CLUTCH UNIT(for 2WW) G

CLUTCH  CLUTCH UNIT(for 2WW)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

a.
C116574

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If the depth is less than the minimum, replace the clutch disc assembly.


b.

Install the clutch disc assembly to the manual transaxle assembly.

NOTICE:

Take care not to insert the clutch disc assembly in the wrong direction.



c.
C299400C03
2.396,3.583 2.708,3.74 0.313,0.156 10 false *a
*a Transaxle Side


Using a dial indicator, measure the clutch disc assembly runout.

Minimum runout:

0.8 mm (0.0314 in.)


If the runout is more than the maximum, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

a.
C116573N02
2.073,0.781 2.219,1.063 0.146,0.281 10 A 2.792,0.469 2.938,0.76 0.146,0.292 10 B

Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

Maximum depth A:

0.5 mm (0.0197 in.)


Maximum width B:

6.0 mm (0.236 in.)


If the depth or width is more than the maximum, replace the clutch cover assembly.


Hide 3.INSPECT FLYWHEEL SUB-ASSEMBLY

a.
C299401

Using a dial indicator with a roller instrument, measure the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.00394 in.)


If the runout is more than the maximum, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

a.
Q001060

Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.


b.

Inspect the clutch release bearing assembly for damage and wear.

If necessary, replace the clutch release bearing assembly.