Home › Drivetrain › K114 MULTIDRIVE / CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2015.10
RM3090E _52 Drivetrain _044380 K114 MULTIDRIVE / CVT _0220923 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K114 MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P2820  Pressure Control Solenoid "J" Performance or Stuck Off  


DESCRIPTION

According to current control by the ECM, the shift solenoid valve SLP controls primary pulley pressure in accordance with the requested gear ratio to perform gear ratio changes.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2820 Pressure Control Solenoid "J" Performance or Stuck Off 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
DTC Detection Condition 1:
1.

The oil pressure sensor output value is 0.333 MPa (3.4 kgf/cm2, 48 psi) or higher and the target gear ratio is less than 1.0.

2.

The actual gear ratio is 2.0 or more.

3.

2 seconds or more

4.

1-trip detection logic


DTC Detection Condition 2:
1.

The oil pressure sensor output value is 0.333 MPa (3.4 kgf/cm2, 48 psi) or higher and the target gear ratio is 2.0 or more.

2.

The actual gear ratio is less than 0.5.

3.

1.5 seconds or more

4.

1-trip detection logic


Continuously variable transaxle assembly (Shift solenoid valve SLP) Comes on DTC stored

MONITOR DESCRIPTION

The ECM compares the actual gear ratio with the target gear ratio. When the actual gear ratio and target gear ratio are different, the ECM detects the problem, illuminates the MIL and stores this DTC.

CAUTION / NOTICE / HINT

NOTICE:
·

Perform initialization when parts related to the continuously variable transaxle are replaced.

Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

·

Check that no DTCs are stored after performing initialization.

Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR



PROCEDURE

1.CHECK DTC OUTPUT (IN ADDITION TO DTC P2820)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

e.

Read the DTCs using the GTS.

HINT:

If any DTCs other than P2820 are output, perform troubleshooting for those DTCs first.



Result:
Result Proceed to
Only DTC P2820 is output A
DTC P2820 and other DTCs are output B



A

2.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY

B

2.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
a.

Replace the continuously variable transaxle assembly.

Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY>REMOVAL


Result:
Proceed to
NEXT



NEXT