Home › Engine / Hybrid System › 2WW FUEL › FUEL PUMP › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221828 FUEL PUMP G

2WW FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 77020A 1.INSPECT FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

a.
A354370C01
0.948,2.01 1.094,2.01 1.094,2.01 1.344,1.333 true 1.417,1.25 1.854,0.698 1.854,0.698 1.979,0.698 true 0.063,0.042 0.375,0.198 0.313,0.156 10 false *a 0.833,1.938 0.99,2.135 0.156,0.198 10 false 4 2.042,0.615 2.198,0.813 0.156,0.198 10 false 5
*a Component without harness connected
(Fuel Suction Tube with Pump and Gauge Assembly)


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 5 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel suction tube with pump and gauge assembly.



b.
A354371C01
1.677,1.802 1.781,1.802 1.781,1.802 2.094,1.135 true 2.104,1.021 2.542,0.156 2.542,0.156 2.677,0.156 true 0.125,0.052 0.438,0.208 0.313,0.156 10 false *a 2.75,0.073 2.906,0.271 0.156,0.198 10 false 4 1.552,1.729 1.708,1.927 0.156,0.198 10 false 5
*a Component without harness connected
(Fuel Suction Tube with Pump and Gauge Assembly)


Check the operation.

i.

Connect the positive (+) lead of the battery to terminal 4 of the connector, and the negative (-) lead to terminal 5. Check that the fuel suction tube with pump and gauge assembly operates.

NOTICE:
·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Keep the fuel suction tube with pump and gauge assembly as far away from the battery as possible.

·

Always switch the voltage on and off at the battery side, not the fuel suction tube with pump and gauge assembly side.



If the fuel suction tube with pump and gauge assembly does not operate, replace the fuel suction tube with pump and gauge assembly.