The 4WD ECU assembly inputs the signals sent from the ECM and skid control ECU (brake actuator assembly), and steering angle sensor (spiral with sensor cable sub-assembly) via the CAN communication system.
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073/86 | Control Module Communication Bus OFF | 1.
When the following continues for 5 seconds or more: ·
Signals from the 4WD ECU assembly are not received. 2.
When the following occurs 10 times consecutively: ·
A communication malfunction (bus off) occurs one or more times within 0.1 seconds. |
·
CAN communication system ·
4WD ECU assembly |
| U0100/85 | Lost Communication with ECM / PCM "A" | 1.
When both of the following continue for 2 seconds or more: ·
The voltage of the IG1 terminal is 10 V or more. ·
At a vehicle speed of 60 km/h (38 mph) or more, communication with the ECM cannot be performed. |
·
CAN communication system ·
4WD ECU assembly ·
ECM |
| U0126/84 | Lost Communication with Steering Angle Sensor Module | 1.
When both of the following continue for 1 second or more: ·
The voltage of the IG1 terminal is 10 V or more. ·
Communication with the steering angle sensor (spiral with sensor cable sub-assembly) cannot be performed. 2.
When all of the following occur 10 times consecutively: ·
The voltage of the IG1 terminal is 10 V or more. ·
The condition that communication with the steering angle sensor (spiral with sensor cable sub-assembly) cannot be performed occurs once within 5 seconds. ·
Occurs 10 times or more within 60 seconds. |
·
CAN communication system ·
4WD ECU assembly ·
Steering angle sensor (Spiral with sensor cable sub-assembly) |
| U0129/83 | Lost Communication with Brake System Control Module | 1.
When the following continues for 3 seconds or more: ·
The voltage of the IG1 terminal is 10 V or more. ·
Communication with the skid control ECU (brake actuator assembly) cannot be performed. |
·
CAN communication system ·
4WD ECU assembly ·
Skid control ECU (Brake actuator assembly) |
Check for DTCs.
Click hereDrivetrain>GF1A TRANSFER / 4WD / AWD>DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM>DTC CHECK / CLEAR
Record the output DTCs (dynamic torque control 4WD/AWD system ).
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.
| Proceed to |
|---|
| NEXT (for LHD with Central Gateway ECU) |
| NEXT (for RHD with Central Gateway ECU) |
| NEXT (for LHD without Central Gateway ECU) |
| NEXT (for RHD without Central Gateway ECU) |
NEXT (for LHD with Central Gateway ECU)
NEXT (for RHD with Central Gateway ECU)
NEXT (for LHD without Central Gateway ECU)
NEXT (for RHD without Central Gateway ECU)