Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY(for 4WD/AWD) › from 2015.10
RM3090E _52 Drivetrain _008761 DRIVE SHAFT / PROPELLER SHAFT _0050236 FRONT DRIVE SHAFT ASSEMBLY(for 4WD/AWD) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 4WD/AWD)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no severe play in the radial direction of the inboard joint.


d.

Check the 2 joint boots for damage.


e.
C278922C01
0.094,0.083 0.406,0.281 0.313,0.198 10 *A 0.094,1.854 0.406,2.052 0.313,0.198 10 *B 1.531,1.573 1.844,1.771 0.313,0.198 10 (A) 1.594,3.104 1.906,3.302 0.313,0.198 10 (A)
*A for LH Side
*B for RH Side


Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.

Length (A):
Item Length
for 2AD-FTV, 2AD-FHV (Automatic Transaxle) LH Side 565.6 mm (1.86 ft.)
RH Side 928.4 mm (3.05 ft.)
for 2AD-FTV, 2AD-FHV (Manual Transaxle) LH Side 553.6 mm (1.82 ft.)
RH Side 933.9 mm (3.06 ft.)
for 2AR-FE (Automatic Transaxle) LH Side 577.6 mm (1.89 ft.)
RH Side 922.4 mm (3.03 ft.)
for 2AR-FE (Manual Transaxle) LH Side 583.6 mm (1.91 ft.)
RH Side 909.4 mm (2.98 ft.)
for 3ZR-FE, 3ZR-FAE (Manual Transaxle) LH Side 594.6 mm (1.95 ft.)
RH Side 896.4 mm (2.94 ft.)
for 3ZR-FE (CVT) LH Side 591.2 mm (1.94 ft.)
RH Side 881.9 mm (2.89 ft.)*1
893.0 mm (2.93 ft.)*2
for 3ZR-FAE (CVT) LH Side 591.2 mm (1.94 ft.)
RH Side 893.0 mm (2.93 ft.)


*1: for K111

*2: for K114

NOTICE:

Keep the drive shaft assembly level during inspection.


If the boots are stretched or contracted, correct them.