Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0224930 ROAD SIGN ASSIST SYSTEM U

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Road Sign Assist / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Road Sign Assist > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RSA Fusion Control RSA fusion control operation status OFF or ON OFF: Not operating
ON: Operating
-
Traffic Sign Speed Unit Unit of speed of traffic sign kph or mph kph: km/h
mph: mph
-
Estimated Traffic Division Detected direction of traffic stored in the forward recognition camera Unconfirmed, Right-hand traffic or Left-hand traffic Unconfirmed: Unconfirmed
Right-hand traffic: Right-hand traffic
Left-hand traffic: Left-hand traffic
-