Home › Engine / Hybrid System › 2WW FUEL › FUEL FILTER › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221825 FUEL FILTER G

2WW FUEL  FUEL FILTER  INSPECTION  


PROCEDURE

Hide 23300 1.INSPECT FUEL FILTER ASSEMBLY

a.
A362722C01
2.365,0.698 2.615,0.885 0.25,0.188 10 false *a 2.365,1.125 2.635,1.333 0.271,0.208 10 false *b
*a Float at upper end position
*b Float at lower end position


Inspect the level warning switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Float at upper end position Below 1 Ω
Float at lower end position 10 kΩ or higher


If the result is not as specified, replace the fuel filter assembly.



b.

Inspect the fuel heater.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.1 to 1 Ω


If the result is not as specified, replace the fuel filter assembly.