Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › from 2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047055 AUTOMATIC HIGH BEAM SYSTEM C

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  B124B  Automatic High Beam System  


DESCRIPTION

This DTC is stored when the main body ECU (multiplex network body ECU) detects malfunction in the automatic high beam system.

When DTCs for the following systems are stored, this DTC is stored simultaneously.

·

Forward recognition camera system malfunction

·

CAN communication system malfunction


DTC No. Detection Item DTC Detection Condition Trouble Area
B124B Automatic High Beam System Malfunction in automatic high beam system
·

Forward recognition camera system

·

CAN communication system

·

Main body ECU (multiplex network body ECU)



WIRING DIAGRAM

E270527E09
0.594,0.771 2.75,1.188 2.156,0.417 10 false Main Body ECU (Multiplex Network Body ECU) 4.365,0.844 6.375,1.156 2.01,0.313 10 false Forward Recognition Camera 0.573,2.302 2.583,2.5 2.01,0.198 10 false : CAN Communication Line


CAUTION / NOTICE / HINT

NOTICE:
·

Confirm that there are no CAN communication system malfunctions before performing the following inspection.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT

·

If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.

·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/o Entry and Start System)>PRECAUTION



PROCEDURE

1.CHECK FOR DTC (ALL)
a.

Connect the Techstream to DLC3.


b.

Turn the ignition switch to ON.


c.

Enter the following menus: System Select / Health Check.


d.

Check for DTCs.


Result:
Result Proceed to
Only DTC B124B is output A
DTC B124B is output at the same time B



A

2.CHECK FORWARD RECOGNITION CAMERA SYSTEM

B

2.CHECK FORWARD RECOGNITION CAMERA SYSTEM

Result:
Proceed to
OK
NG



OK

NG