Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY(for RH Side) › from 2015.10
RM3090E _58 Vehicle Interior _008433 SEAT _0049738 REAR SEAT ASSEMBLY(for RH Side) A

SEAT  REAR SEAT ASSEMBLY(for RH Side)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the seatback frame, seat cushion frame and reclining adjuster may injure your hands.


PROCEDURE

Hide 79915 1.INSTALL SEAT LEG BRACKET

a.
B336604

Attach the guide.


b.

Attach the clamp and install the seat leg bracket with the 4 bolts.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 2.INSTALL REAR SEAT ASSEMBLY RH

a.

Fully tilt the seatback forward.


b.

Place the rear seat assembly RH in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



c.

Temporarily install the rear seat assembly RH with the 5 bolts.


d.
B336606C04
0.563,0.802 0.781,0.802 0.781,0.802 1.021,1.104 false 1.177,1.635 1.385,1.813 0.208,0.177 10 false (1) 3,1.385 3.198,1.583 0.198,0.198 10 false (2) 3.229,0.063 3.417,0.271 0.188,0.208 10 false (3) 0.406,0.729 0.719,0.927 0.313,0.198 10 false *1
*1 Rubber Band


Tighten the 3 bolts on the rear side of the seat.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



e.

w/ Seat Belt Warning System:

Connect the 2 connectors.


f.

Pass the rear seat center lap type belt assembly RH through the rubber band of the separate type rear seat cushion cover.


g.
B429033

w/ Seat Heater System:

i.

Attach the wire harness clamp.


ii.

Connect the connector.



h.
B336603N01
1.427,1.729 1.646,1.927 0.219,0.198 10 false (1) 0.156,0.583 0.354,0.781 0.198,0.198 10 false (2)

Tighten the 2 bolts on the front side of the seat.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



Hide 79965 3.INSTALL REAR SEAT NO. 2 LEG SIDE COVER

a.
B336598

Attach the 4 claws to install the rear seat No. 2 leg side cover.


Hide 79955A 4.INSTALL REAR SEAT FRONT BRACKET COVER RH

a.
B336600

Attach the 2 guides and 4 claws to install the rear seat front bracket cover RH in the direction shown by the arrow in the illustration.


Hide 5.CHECK SEAT HEATER SYSTEM