Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH(for Rear Seat) › from 2015.10
RM3090E _58 Vehicle Interior _008433 SEAT _0226876 SEAT HEATER SWITCH(for Rear Seat) G

SEAT  SEAT HEATER SWITCH(for Rear Seat)  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 84751R 1.INSPECT REAR SEAT HEATER SWITCH

a.
B429052C01
2.49,2.76 2.906,2.344 true 2.073,2.75 2.552,2.125 true 1.552,2.75 1.115,2.063 true 1.135,2.76 0.604,2.115 true 0.927,2.781 0.396,2.354 true 0.188,1.688 0.5,1.844 0.313,0.156 10 false *a 0.146,2.26 0.458,2.458 0.313,0.198 10 false IND 2.552,1.927 2.865,2.125 0.313,0.198 10 false ILL+ 2.938,2.146 3.25,2.344 0.313,0.198 10 false IG 1.01,1.875 1.323,2.073 0.313,0.198 10 false R 0.448,1.938 0.604,2.146 0.156,0.208 10 false E
*a Component without harness connected
(Rear Seat Heater Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (IG) - 7 (E) Rear seat heater switch on Below 1 Ω


If the result is not as specified, replace the rear seat heater switch.


b.

Apply battery voltage to the rear seat heater switch connector, and check that the rear seat heater switch indicator illuminates.

OK:
Measurement Condition Switch Condition Specified Condition
Battery positive (+) → 1 (IG)
Battery negative (-) → 8 (IND)
Rear seat heater switch on Indicator illuminates


If the result is not as specified, replace the rear seat heater switch.


c.

Apply battery voltage to the rear seat heater switch connector, and check that the rear seat heater switch illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3 (ILL+)
Battery negative (-) → 5 (R)
Illuminates


If the result is not as specified, replace the rear seat heater switch.