Home › Engine / Hybrid System › CRUISE CONTROL › SPEED LIMITER SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0226926 SPEED LIMITER SYSTEM C

CRUISE CONTROL  SPEED LIMITER SYSTEM  P0500  Vehicle Speed Sensor "A"  


DESCRIPTION

The wheel speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU (brake actuator assembly).

The skid control ECU (brake actuator assembly) converts the wheel speed signal into a 4-pulse signal and transmits it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of the pulse signal.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0500 Vehicle Speed Sensor "A" When driving vehicle with speed limiter system operating, vehicle speed signal is not sent to ECM.
·

Open or short in speedometer circuit

·

Speedometer assembly

·

ECM



HINT:

For vehicles with a speed limiter system, detection does not start unless the following conditions are met.

·

Speed limiter switch is ON.

·

Average time period between speed pulses is a non-zero value and frozen for a calibrated time.

·

Sensed vehicle speed is greater than a calibrated threshold.

·

Engine is running.



CAUTION / NOTICE / HINT

HINT:

This DTC may be stored by the ECD system at the same time. In that case, perform troubleshooting for the ECD system first.


PROCEDURE

1.CHECK FOR DTCs (DTC P0500)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>SPEED LIMITER SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine and ECT > Trouble Codes
50001 371

Result:
Result Proceed to
DTC is not output A
DTC P0500 is output B



A

B