47201
1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure the tip of the master cylinder points downward when handling the master cylinder.
Make sure foreign matter does not adhere to the piston of the master cylinder. If foreign matter adheres, it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
Install a new O-ring to the master cylinder.
Install the master cylinder to the booster with the 2 nuts.
Using a union nut wrench, connect the 2 brake lines labeled C to the master cylinder.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Connect the brake fluid level warning switch connector labeled B to the master cylinder.
for Manual Transaxle:
Connect the clutch reservoir tube labeled A to the master cylinder.
2.BLEED BRAKE SYSTEM
3.BLEED CLUTCH LINE (for Manual Transaxle)
for 2AD-FTV:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 2AD-FTV)>BLEEDING
for 2AR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 2AR-FE)>BLEEDING
for 3ZR-FE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 3ZR-FE)>BLEEDING
for 3ZR-FAE:
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM(for 3ZR-FAE)>BLEEDING
for 2WW: