Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2015.10
RM3090E _59 Vehicle Exterior _008798 EXTERIOR PANELS / TRIM _0050008 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 53896B 1.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH

a.
B425577

Remove the 3 screws.


b.

Detach the clamp and remove the front fender front splash shield LH.


Hide 53895B 2.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

HINT:

Use the same procedure described for the LH side.


Hide 52119A 3.REMOVE FRONT BUMPER COVER

a.
B427338

Remove the 4 screws.


b.
B425579C02
0.698,1.156 0.948,1.406 0.25,0.25 10 true *a
*a 90°


Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip and screw.

HINT:

Use the same procedure for the other side.



c.
B427336C01
0.969,0.479 0.969,0.219 0.969,0.219 1.219,0.219 true 1.229,0.729 1.229,0.469 1.229,0.469 1.417,0.469 true 1.792,0.771 1.792,0.313 1.792,0.313 2.021,0.313 true 1.458,0.385 1.667,0.594 0.208,0.208 10 true *1 1.25,0.135 1.458,0.344 0.208,0.208 10 true *2 2.052,0.24 2.26,0.448 0.208,0.208 10 true *2
*1 Center Hood Cushion
*2 Radiator Grille Protector


Remove the center hood cushion and 2 radiator grille protectors.


d.

Remove the 2 bolts and clip.


e.
B437121C01
0,0 0,0 false
V100155

Protective Tape


Put protective tape around the front bumper cover.


f.
B427340C02
0,0 0,0 false

Detach the 8 claws and remove the front bumper cover.


g.

w/ Fog Light:

Disconnect the 2 fog light connectors.


h.

w/ Pre-crash Safety System, w/ TOYOTA Parking Assist-sensor System:

Disconnect the No. 3 engine room wire connector.


i.

w/ Headlight Cleaner System:

Disconnect the headlight washer hose, and then drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 52614 4.REMOVE FRONT BUMPER NO. 2 ENERGY ABSORBER

a.
B427342

Remove the front bumper No. 2 energy absorber.


Hide 86510 5.REMOVE HIGH PITCHED HORN ASSEMBLY

Hide 86520 6.REMOVE LOW PITCHED HORN ASSEMBLY

Hide 88625P 7.REMOVE COOLER (AMBIENT TEMPERATURE SENSOR) THERMISTOR

Hide 52085 8.REMOVE FRONT BUMPER CENTER STAY SUB-ASSEMBLY

a.
B425584

Remove the 2 bolts and front bumper center stay sub-assembly.


Hide 52131A 9.REMOVE FRONT BUMPER REINFORCEMENT

a.
B432957

Detach the 2 clamps.


b.

Remove the 8 bolts and front bumper reinforcement.


Hide 11.REMOVE HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52536 12.REMOVE FRONT BUMPER SIDE RETAINER LH

B344658C02
2.906,0.354 3.177,0.583 0.271,0.229 10 false *a
*a 90°


a.

Using a screwdriver, turn the clip 90° and remove the clip.


b.

Remove the screw.


c.

Detach the claw and remove the front bumper side retainer LH.


Hide 52535 13.REMOVE FRONT BUMPER SIDE RETAINER RH

HINT:

Use the same procedure described for the LH side.


Hide 52029 14.REMOVE FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY

a.
B425588

Remove the 2 clips.


b.

Remove the 2 bolts and front bumper upper reinforcement sub-assembly.