A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
52029
1.INSTALL FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper upper reinforcement sub-assembly with the 2 bolts.
Install the 2 clips.
52536
2.INSTALL FRONT BUMPER SIDE RETAINER LH
Attach the claw to install the front bumper side retainer LH.
Install the screw.
Install the clip.
52535
3.INSTALL FRONT BUMPER SIDE RETAINER RH
Use the same procedure described for the LH side.
4.INSTALL HEADLIGHT ASSEMBLY LH
for Halogen Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>INSTALLATION
for LED Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>INSTALLATION
5.INSTALL HEADLIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52131A
6.INSTALL FRONT BUMPER REINFORCEMENT
Install the front bumper reinforcement with the 8 bolts.
Attach the 2 clamps.
52085
7.INSTALL FRONT BUMPER CENTER STAY SUB-ASSEMBLY
Install the front bumper center stay sub-assembly with the 2 bolts.
88625P
8.INSTALL COOLER (AMBIENT TEMPERATURE SENSOR) THERMISTOR
86510
9.INSTALL HIGH PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>INSTALLATION
86520
10.INSTALL LOW PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>INSTALLATION
52614
11.INSTALL FRONT BUMPER NO. 2 ENERGY ABSORBER
Install the front bumper No. 2 energy absorber.
52119A
12.INSTALL FRONT BUMPER COVER
w/ Fog Light:
Connect the 2 fog light connectors.
w/ Pre-crash Safety System, w/ TOYOTA Parking Assist-sensor System:
Connect the No. 3 engine room wire connector.
w/ Headlight Cleaner System:
Connect the headlight washer hose.
Attach the 8 claws to install the front bumper cover.
Install the 2 bolts and clip.
Install the center hood cushion and 2 radiator grille protectors.
| *a | Correct |
| *b | Incorrect |
Install the pin hold clip and screw.
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.
Use the same procedure for both pin hold clips and screws.
Install the 4 screws.
w/ Headlight Cleaner System:
Fill the washer jar with washer fluid.
53896B
13.INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
Attach the clamp to install the front fender front splash shield LH.
Install the 3 screws.
53895B
14.INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
Use the same procedure described for the LH side.
15.ADJUST HEADLIGHT AIMING
for Halogen Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>ADJUSTMENT
for LED Headlight:
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for LED Headlight)>ADJUSTMENT
16.ADJUST FOG LIGHT AIMING (w/ Fog Light)