Home › Vehicle Interior › MIRROR (INT) › INNER REAR VIEW MIRROR › from 2015.10
RM3090E _58 Vehicle Interior _008785 MIRROR (INT) _0050098 INNER REAR VIEW MIRROR G

MIRROR (INT)  INNER REAR VIEW MIRROR  INSPECTION  


PROCEDURE

Hide 87810 1.INSPECT INNER REAR VIEW MIRROR ASSEMBLY (w/ EC Mirror)

a.

Check operation of the electrochromic inner mirror.

B437864C01
6.188,1.313 6.188,0.823 true 6.823,1.354 6.823,1.125 true 6.76,1.375 7.073,1.531 0.313,0.156 10 false *1 6.115,1.354 6.427,1.51 0.313,0.156 10 false *2 0.25,1.385 0.563,1.542 0.313,0.156 10 false *3 1,0.104 1.313,0.26 0.313,0.156 10 false *a 2.969,2.167 3.281,2.323 0.313,0.156 10 false *b 4.896,2.198 5.208,2.354 0.313,0.156 10 false *c
*1 Black Colored Tape *2 Forward Sensor
*3 Battery - -
*a Component without harness connected
(Inner Rear View Mirror Assembly)
*b Bright
*c Dark - -


i.

Connect the battery positive (+) lead to terminal 1 (IG) and the negative (-) lead to terminal 2 (E).


ii.

Press the AUTO switch.


iii.

Attach black colored tape to the forward sensor to prevent it from sensing light.


iv.

Shine an electric light on the mirror. Check that the mirror surface changes from bright to dark.

HINT:

When the environment is very bright, the antiglare operation may occur immediately after the tape is applied.


If the result is not as specified, replace the inner rear view mirror assembly.



Hide 87810 2.INSPECT INNER REAR VIEW MIRROR ASSEMBLY (w/ Pre-crash Safety System)

a.

Check operation of the electrochromic inner mirror.

B437863C01
6.292,1.333 6.292,0.885 true 6.906,1.5 6.906,1.208 true 6.844,1.542 7.156,1.698 0.313,0.156 10 false *1 6.24,1.354 6.552,1.51 0.313,0.156 10 false *2 0.448,1.49 0.76,1.646 0.313,0.156 10 false *3 1.094,0.125 1.406,0.281 0.313,0.156 10 false *a 3.177,2.198 3.49,2.354 0.313,0.156 10 false *b 4.99,2.188 5.302,2.344 0.313,0.156 10 false *c
*1 Black Colored Tape *2 Forward Sensor
*3 Battery - -
*a Component without harness connected
(Inner Rear View Mirror Assembly)
*b Bright
*c Dark - -


i.

Connect the battery positive (+) lead to terminal 4 (IG) and the negative (-) lead to terminal 1 (E).


ii.

Press the AUTO switch.


iii.

Attach black colored tape to the forward sensor to prevent it from sensing light.


iv.

Shine an electric light on the mirror. Check that the mirror surface changes from bright to dark.

HINT:

When the environment is very bright, the antiglare operation may occur immediately after the tape is applied.


If the result is not as specified, replace the inner rear view mirror assembly.