Use this procedure to troubleshoot the immobiliser system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
The following 5 items are important points for problem analysis:
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Whether the problem occurs at a specific location. |
| Under what conditions? | Whether the doors were locked or unlocked, whether the ignition switch was ON, whether the engine was running. |
| How did it happen? | Problem symptoms |
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| SFI system DTCs are output (for 2AR-FE [w/ Canister Pump Module]) | B |
| SFI system DTCs are output (for 2AR-FE [w/o Canister Pump Module]) | C |
| SFI system DTCs are output (for 3ZR-FAE) | D |
| SFI system DTCs are output (for 3ZR-FE [for K111, K111F]) | E |
| SFI system DTCs are output (for 3ZR-FE [except K111, K111F]) | F |
| ECD system DTCs are output (for 2WW) | G |
| ECD system DTCs are output (for 2AD-FTV [for CCo]) | H |
| ECD system DTCs are output (for 2AD-FTV [for DPF]) | I |
| ECD system DTCs are output (for 2AD-FHV) | J |
| Immobiliser system DTCs are output | K |
A
B
C
D
E
F
G
H
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for CCo)>DIAGNOSTIC TROUBLE CODE CHART
I
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DIAGNOSTIC TROUBLE CODE CHART
J
K
Check for DTCs and note any codes that are output.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
| Proceed to |
|---|
| DTCs are not output |
| Immobiliser system DTCs are output |
DTCs are not output
Immobiliser system DTCs are output
Refer to Problem Symptoms Table.
| Proceed to |
|---|
| Fault is not listed in problem symptoms table |
| Fault is listed in problem symptoms table |
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Data List / Active Test
| Proceed to |
|---|
| NEXT |
NEXT
If the transponder key ECU assembly, ECM, or key is replaced, refer to the Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
| Proceed to |
|---|
| DTCs are not output |
| Immobiliser system DTCs are output |
DTCs are not output
Immobiliser system DTCs are output