The blind spot monitor sensor receives vehicle speed signals from the brake actuator assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the brake actuator assembly. | ·
Vehicle stability control system ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is on.
Check for vehicle stability control system DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| Vehicle stability control system DTCs are not output |
| Vehicle stability control system DTCs are output |
Vehicle stability control system DTCs are not output
Vehicle stability control system DTCs are output
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTC is output |
| DTC is output from the blind spot monitor sensor LH (master) |
| DTC is output from the blind spot monitor sensor RH (slave) |
No DTC is output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC is output from the blind spot monitor sensor LH (master)
DTC is output from the blind spot monitor sensor RH (slave)