The blind spot monitor sensor receives steering angle signals from the spiral with sensor cable sub-assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A47 | Steering Angle Sensor | A fail flag is transmitted from the spiral with sensor cable sub-assembly | ·
Spiral with sensor cable sub-assembly ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is on.
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output
Replace the spiral with sensor cable sub-assembly.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTC is output |
| DTC is output from the blind spot monitor sensor LH (master) |
| DTC is output from the blind spot monitor sensor RH (slave) |
No DTC is output
DTC is output from the blind spot monitor sensor LH (master)
DTC is output from the blind spot monitor sensor RH (slave)