This DTC is stored when the blind spot monitor sensor RH detects a ground short in the outer rear view mirror indicator RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB3 | Short to GND in Outer Mirror Indicator(Slave) | Both of the following conditions are met:
·
Blind spot monitor system is on. ·
The current that is sent from the blind spot monitor sensor to the indicator is above a specified level for a specified period of time. |
·
Outer rear view mirror sub-assembly RH (outer rear view mirror indicator RH) ·
Outer rear view mirror assembly RH ·
Blind spot monitor sensor RH ·
Harness or connector |
When checking for DTCs, make sure that the blind spot monitor system is on.
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output
Disconnect the T1 blind spot monitor sensor RH connector.
Disconnect the I8*1 or I14*2 outer rear view mirror assembly RH connector.
*1: w/o Panoramic View Monitor System
*2: w/ Panoramic View Monitor System
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I8-1 (BSR+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer rear view mirror sub-assembly RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>REMOVAL
Inspect the outer rear view mirror sub-assembly RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the outer rear view mirror assembly RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
DTCs are output