This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor has been replaced.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB8 | Destination Information Undefined | The blind spot monitor sensor cannot communicate with the main body ECU (multiplex network body ECU). | ·
CAN communication system (for LHD) ·
CAN communication system (for RHD) ·
Main body ECU (multiplex network body ECU) ·
Blind spot monitor sensor LH ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is on.
When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.
for LHD
Check for CAN Communication System DTCs.
for RHD
Check for CAN Communication System DTCs.
| Proceed to |
|---|
| CAN communication system DTCs are not output |
| CAN communication system DTCs are output (for LHD) |
| CAN communication system DTCs are output (for RHD) |
CAN communication system DTCs are not output
CAN communication system DTCs are output (for LHD)
CAN communication system DTCs are output (for RHD)
for LHD
Replace the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
for RHD
Replace the main body ECU (multiplex network body ECU).
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTC is output |
| DTC is output from the blind spot monitor sensor LH (Master) |
| DTC is output from the blind spot monitor sensor RH (Slave) |
No DTC is output
DTC is output from the blind spot monitor sensor LH (Master)
DTC is output from the blind spot monitor sensor RH (Slave)