Home › Drivetrain › CLUTCH › CLUTCH UNIT(for 2AD-FTV) › from 2015.10
RM3090E _52 Drivetrain _008754 CLUTCH _0227800 CLUTCH UNIT(for 2AD-FTV) G

CLUTCH  CLUTCH UNIT(for 2AD-FTV)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

a.
C116574

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If the depth is less than the minimum, replace the clutch disc assembly.


b.

Install the clutch disc assembly to the manual transaxle assembly.

NOTICE:

Take care not to insert the clutch disc in the wrong direction.



c.
C280827C01
2.281,3.51 2.594,3.708 0.313,0.198 10 *a
*a Transaxle Side


Using a dial indicator, measure the clutch disc assembly runout.

Minimum runout:

0.8 mm (0.0314 in.)


If the runout is more than the maximum, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

a.
C116573N02
2.073,0.781 2.219,1.063 0.146,0.281 10 A 2.792,0.469 2.938,0.76 0.146,0.292 10 B

Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

Maximum depth A:

0.5 mm (0.0196 in.)


Maximum width B:

6.0 mm (0.236 in.)


If the depth or width is more than the maximum, replace the clutch cover assembly.


Hide 3.INSPECT FLYWHEEL SUB-ASSEMBLY

a.
C280828

Using a dial indicator, measure the flywheel runout.

Maximum runout:

0.1 mm (0.00393 in.)


If the runout is more than the maximum, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

a.
Q001060

Turn the release bearing by hand while applying force in the axial direction.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.

Replace the release bearing assembly as necessary.