84794A
1.REMOVE FRONT WIPER DEICER RELAY
Remove the front wiper deicer relay from the engine room relay block.
84794A
2.INSPECT FRONT WIPER DEICER RELAY (HWD NO. 1)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the front wiper deicer relay.
84794A
3.INSPECT FRONT WIPER DEICER RELAY (HWD NO. 2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the front wiper deicer relay.
84794A
4.INSTALL FRONT WIPER DEICER RELAY
Install the front wiper deicer relay to the engine room relay block.