Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › from 2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050200 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81561D 1.REMOVE REAR COMBINATION LIGHT LENS AND BODY LH

a.
E332616C01
0,0 0,0 false
V100155

Protective Tape


Put protective tape around the rear combination light assembly LH.


b.

Remove the 2 bolts.


c.

Pull the rear combination light assembly LH towards the rear of the vehicle to detach the pin and guide and disconnect it.


d.
E338914

Disconnect the 2 connectors.


e.
E332622C01
1.198,2.021 1.479,1.146 true 1.167,4.375 1.167,3.646 true 1.094,2.052 1.406,2.208 0.313,0.156 10 false *a 1.104,4.406 1.417,4.563 0.313,0.156 10 false *b
*a Matchmark
*b Unlock Position Mark


Turn the rear turn signal light bulb socket counterclockwise until the matchmark is aligned with the unlock position mark to disconnect the rear turn signal light bulb socket.


f.

Detach the wire harness clamp.


Hide 81536A 2.REMOVE REAR COMBINATION LIGHT LED

a.
E338915

Using a T20H "TORX" screwdriver, remove the "TORX" screw.


b.
E338916C01
0.917,2.104 1.646,1.292 true 2.448,3.792 1.948,3.792 true 0.792,2.104 1.104,2.26 0.313,0.156 10 false *a 2.5,3.698 2.719,3.885 0.219,0.188 10 true *b
*a Matchmark
*b Unlock Position Mark


Turn the rear combination light LED counterclockwise until the matchmark is aligned with the unlock position mark to remove the rear combination light LED.


Hide 81550L 3.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E269011

Remove the rear turn signal light bulb from the bulb socket.