Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY › from 2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050200 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 81550L 1.INSTALL REAR TURN SIGNAL LIGHT BULB

a.
E269012

Install the rear turn signal light bulb to the rear turn signal light bulb socket.


Hide 81536A 2.INSTALL REAR COMBINATION LIGHT LED

a.
E338917C01
1.865,1.24 2.396,1.24 true 1.688,1.646 1.948,1.344 true 1.49,4.281 1.667,3.927 true 2.458,1.125 2.698,1.313 0.24,0.188 10 true *a 1.563,1.667 1.781,1.865 0.219,0.198 10 true *b 1.396,4.313 1.594,4.552 0.198,0.24 10 true *c
*a Matchmark
*b Unlock Position Mark
*c Lock Position Mark


Align the matchmark of the rear combination light LED to the unlock position mark, and then rotate the rear combination light LED clockwise until the lock position mark to install the rear combination light LED.


b.

Using a T20H "TORX" screwdriver, install the "TORX" screw.


Hide 81561D 3.INSTALL REAR COMBINATION LIGHT LENS AND BODY LH

a.
E332617C01
0.771,0.865 1.854,1.052 true 2.031,0.844 2.344,0.469 true 2.146,3.75 2.552,4.344 true 0.583,0.75 0.781,0.958 0.198,0.208 10 true *a 2.385,0.354 2.594,0.552 0.208,0.198 10 true *b 2.51,4.385 2.708,4.583 0.198,0.198 10 true *c
*a Matchmark
*b Unlock Position Mark
*c Lock Position Mark


Align the matchmark of the rear turn signal light bulb socket to the unlock position mark, and then rotate the rear turn signal light bulb socket clockwise until the lock position mark to connect the rear turn signal light bulb socket.


b.

Connect the 2 connectors.


c.
E335257C01
0,0 0,0 false
V100155

Protective Tape


Slide the rear combination light assembly LH towards the vehicle front to attach the pin and guide.


d.

Install the 2 bolts.