Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
67939B
1.REMOVE CENTER BACK DOOR GARNISH
67938A
2.REMOVE BACK DOOR SIDE GARNISH LH
67937B
3.REMOVE BACK DOOR SIDE GARNISH RH
67750
4.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
84280D
5.REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
6.REMOVE REAR LIGHT ASSEMBLY LH
|
Protective Tape |
Put protective tape around the rear light assembly LH.
Disconnect the connector.
Pull the rear light assembly LH towards the rear of the vehicle to remove it.
If the rear light assembly LH is removed, replace the rear light gasket LH with a new one.