Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0050195 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
E233306C51
1.49,0.281 1.854,0.5 0.365,0.219 1.292,1.167 1.042,1.854 true 2.281,1.115 2.656,0.958 true 1.958,1.177 1.708,1.865 true 0.115,0.104 0.344,0.271 0.229,0.167 10 false *a 1.552,0.302 1.979,0.521 0.427,0.219 10 false A77 2.708,0.875 2.875,1.042 0.167,0.167 10 false B 0.906,1.896 1.417,2.135 0.51,0.24 10 false GND 1.667,1.896 1.833,2.063 0.167,0.167 10 false B
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


Disconnect the stop light switch assembly connector.


b.

Measure the resistance and voltage on the wire harness side connector according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A77-2 (GND) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Condition Specified Condition
A77-7 (B) - A77-2 (GND) Always 11 to 14 V
A77-6 (B) - A77-2 (GND) Ignition switch on (IG) 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


c.

Reconnect the stop light switch assembly connector.


d.
E233300C25
1.51,0.271 1.865,0.521 0.354,0.25 1.927,1.115 2.406,1.677 true 2.073,1.063 2.531,0.76 true 1.813,1.115 1.99,1.677 true 1.688,1.115 1.167,1.677 true 1.26,0.594 1.542,1.063 true 0.188,0.115 0.417,0.281 0.229,0.167 10 false *a 1.583,0.313 2.031,0.573 0.448,0.26 10 false A77 2.583,0.677 3.031,0.896 0.448,0.219 10 false OUT 2,1.708 2.313,1.917 0.313,0.208 10 false L 2.302,1.698 2.802,1.917 0.5,0.219 10 false GND 1,1.698 1.448,1.958 0.448,0.26 10 false ACC 1.167,0.49 1.479,0.698 0.313,0.208 10 false L
*a Component with harness connected
(Stop Light Switch Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A77- 1 (OUT) - A77-2 (GND) Brake pedal not depressed 0 to 1.5 V
A77-1 (OUT) - A77-2 (GND) Brake pedal depressed 7.5 to 14 V
A77-3 (L) - A77-2 (GND) Brake pedal not depressed 7.5 to 14 V
A77-3 (L) - A77-2 (GND) Brake pedal depressed 0 to 1.5 V
A77-4 (ACC) - A77-2 (GND) IG ON 11 to 14 V
A77-5 (L) - A77-2 (GND) Brake pedal not depressed 7.5 to 14 V
A77-5 (L) - A77-2 (GND) Brake pedal depressed 0 to 1.5 V


If the result is not as specified, replace the stop light switch assembly.