Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › 2015.10–2016.08
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0230681 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REASSEMBLY  


PROCEDURE

Hide 44546A 1.INSTALL BRAKE ACTUATOR BOLT CUSHION

a.

Install the 4 brake actuator bolt cushions to the brake actuator bracket assembly.


Hide 2.INSTALL BRAKE ACTUATOR CASE COLLAR

a.

Install the 4 brake actuator case collars to the brake actuator bolt cushions.

NOTICE:

Make sure the brake actuator case collars are in full contact with the brake actuator bolt cushions.



Hide 44590 3.INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY

a.
C306190N01
0.823,0.885 0.979,1.083 0.156,0.198 10 false A 0.958,0.708 1.094,0.906 0.135,0.198 10 false B 1.75,1.417 1.906,1.615 0.156,0.198 10 true C 2.146,0.042 2.302,0.24 0.156,0.198 10 false D

Install the brake actuator bracket assembly to the brake actuator assembly with the 4 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Tighten the 4 bolts uniformly in alphabetical order.

·

A new brake actuator is filled with brake fluid. Therefore, make sure to connect the brake tube before removing the hole plug.