81260C
1.REMOVE MAP LIGHT BULB
Turn the 2 map light bulb sockets in the direction indicated by the arrow in the illustration to remove them from the map light.
Remove the map light bulb from the map light bulb socket.
Use the same procedure for both map light bulbs.
2.REMOVE NO. 2 MAP LIGHT LENS
| *1 | Protective Tape |
Put protective tape around the No. 2 map light lens.
Using a screwdriver, detach the 2 claws and guide and remove the No. 2 map light lens.
Tape the screwdriver tip before use.
3.REMOVE NO. 1 MAP LIGHT LENS
Use the same procedure described for the No. 2 map light lens side.