Use the same procedure for RHD and LHD vehicles..
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
58901A
1.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
Install the rear console box sub-assembly with the 4 bolts and 2 screws.
Attach the clamp.
| *1 | Screw | *2 | Bolt |
58903A
2.INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY
Connect the connector.
Attach the 4 clips and 2 claws to install the console rear end panel sub-assembly.
55434B
3.INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Attach the 5 clips to install the lower center instrument panel finish panel.
58815A
4.INSTALL CONSOLE BOX CARPET
Install the console box carpet.
58805C
5.INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
Attach the 4 claws to install the upper rear console panel sub-assembly.
55395C
6.INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
Attach the guide and 2 clips to install the inner No. 1 instrument panel bracket cover LH.
55394D
7.INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH
Attach the guide and 2 clips to install the inner No. 1 instrument panel bracket cover RH.
58804A
8.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Manual Transaxle)
Attach the 12 clips to install the upper console panel sub-assembly.
Lower the shift lever boot to connect it to the shift lever assembly.
58804A
9.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (except Manual Transaxle)
Connect the connector.
Attach the 12 clips to install the upper console panel sub-assembly.
58809B
10.INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
Attach the 9 clips and claw to install the parking brake hole cover sub-assembly.
33504F
11.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.
33504F
12.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (except Manual Transaxle)
Twist the shift lever knob sub-assembly in the direction indicated by the arrow to install it.