Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
75736B
1.REMOVE FRONT DOOR LOWER OUTSIDE MOULDING LH
When removing the front door lower outside moulding LH, heat the front door panel and front door lower outside moulding LH using a heat light.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| Front Door Lower Outside Moulding LH | 20 to 30°C (68 to 86°F) |
Do not heat the front door panel and front door lower outside moulding LH excessively.
Detach the 6 clips.
Remove the hole plug and nut.
| *a | Double-sided Tape |
|
Protective Tape |
Put protective tape around the front door lower outside moulding LH.
Using moulding remover D, remove the double-sided tape to detach the 8 clips and remove the front door lower outside moulding LH.
Be careful not to damage the vehicle body.