Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
75742E
1.INSTALL REAR DOOR OUTSIDE MOULDING LH
When installing the rear door outside moulding LH, heat the rear door panel and rear door outside moulding LH using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| rear door outside moulding LH | 20 to 30°C (68 to 86°F) |
Do not heat the rear door panel and rear door outside moulding LH excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body surface.
Wipe off any tape adhesive residue with cleaner.
| *a | Double-sided Tape |
Install the rear door outside moulding LH.
Using a heat light, heat the rear door outside moulding LH and the vehicle body surface.
Remove the peeling paper from the face of the rear door upper outside moulding pad.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the 6 clips and double-sided tape to install the rear door outside moulding LH.
Press the rear door outside moulding LH firmly to install it.