Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
75742E
1.REMOVE REAR DOOR OUTSIDE MOULDING LH
When removing the rear door outside moulding LH, heat the rear door panel and rear door outside moulding LH moulding using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Panel | 40 to 60°C (104 to 140°F) |
| Rear Door Outside Moulding LH | 20 to 30°C (68 to 86°F) |
Do not heat the rear door panel and rear door outside moulding LH excessively.
Detach the 4 clips.
Remove the hole plug and nut.
| *a | Double-sided Tape |
|
Protective Tape |
Put protective tape around the rear door outside moulding LH.
Using moulding remover D, remove the double-sided tape to detach the 6 clips and remove the rear door outside moulding LH.
Be careful not to damage the vehicle body.