Use the following procedure to troubleshoot the TOYOTA parking assist-sensor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output (for LHD) | B |
| CAN communication system DTCs are output (for RHD) | C |
A
B
C
| Proceed to |
|---|
| NEXT |
NEXT
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output (Problem symptom does not occur) | B |
| DTC is not output (Problem symptom occurs) | C |
A
B
C
Refer to Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Symptom Simulation.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test
| Proceed to |
|---|
| NEXT |
NEXT
Adjust, repair or replace as necessary.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT