Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 8 Sensor Type) › from 2015.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0232443 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 8 Sensor Type) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 8 Sensor Type)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E335280E02
0.365,2.094 0.979,2.292 0.615,0.198 10 false G166 2.604,1.615 2.76,1.813 0.156,0.198 10 false E 2.594,0.594 2.906,0.792 0.313,0.198 10 false IG 2.906,0.333 3.063,0.531 0.156,0.198 10 false 1 3.948,0.635 4.719,0.833 0.771,0.198 10 false GAUGE 2.885,1.375 3.198,1.573 0.313,0.198 10 false 30 0.375,2.25 4.958,2.448 4.583,0.198 10 false Clearance Warning ECU Assembly 5.531,0.469 7.156,0.729 1.625,0.26 10 false from IG1 NO.2 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY AND BODY GROUND)
a.
E309541C10
1.448,0.25 1.948,0.5 0.5,0.25 0.479,0.979 0.292,0.573 true 1.979,1.583 1.792,1.177 true 1.531,0.302 1.99,0.5 0.458,0.198 10 false G166 0.104,0.49 0.563,0.688 0.458,0.198 10 false IG 0.135,0.094 0.448,0.292 0.313,0.198 10 false *a 1.958,1.646 2.115,1.844 0.156,0.198 10 false E
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)


Disconnect the clearance warning ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G166-30 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) on the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G166-1 (IG) - Body ground Ignition switch ON 11 to 14 V
G166-1 (IG) - Body ground Ignition switch off Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR