Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › from 2015.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0232444 PANORAMIC VIEW MONITOR SYSTEM U

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  TERMINALS OF ECU  


PARKING ASSIST ECU


C280359N05
4.646,0.583 5.01,0.844 0.365,0.26 3.385,0.583 3.75,0.844 0.365,0.26 4.75,0.646 5.208,0.844 0.458,0.198 10 false a2 3.49,0.646 3.948,0.844 0.458,0.198 10 false a1

a.

Disconnect the a2 parking assist ECU connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition

*1: w/o Stop and Start System

*2: w/ Stop and Start System

a2-2 (+B) - a2-3 (GND1) SB - BR Power source signal Always 11 to 14 V*1
10.5 to 16 V*2
a2-3 (GND1) - Body ground BR - Body ground Ground Always Below 1 Ω
a2-6 (IG) - a2-3 (GND1) G - BR IG power source signal Engine switch on (IG) 11 to 14 V*1
10.5 to 16 V*2
Engine switch off Below 1 V
a2-1 (ACC) - a2-3 (GND1) GR - BR ACC power source signal Engine switch on (ACC) 11 to 14 V*1
10.5 to 16 V*2
Engine switch off Below 1 V


c.

Reconnect the a2 parking assist ECU connector.


d.

Measure the voltage, resistance and waveform according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
a2-9 (TX-) P AVC-LAN communication signal - -
a2-10 (TX+) SB AVC-LAN communication signal - -
a1-1 (CV+) - a1-9 (CGND) W - Shielded Rear television camera display signal input Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens not covered, displaying image Pulse generation (See waveform 1)
Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens covered, blacking out screen Pulse generation (See waveform 2)
a1-3 (CB+) - a1-9 (CGND) B - Shielded Power source to rear television camera Engine switch on (IG) 5.5 to 7.05 V
a2-20 (BLSW) - Body ground BE - Body ground Telltale light assembly (panoramic view monitor main switch) switch signal Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) off 5.5 to 6.5 V
Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on Below 1 V
a1-9 (CGND) - a2-3 (GND1) Shielded - BR Rear television camera ground (shield) Always Below 1 Ω
a1-2 (CV-) - a1-9 (CGND) R - Shielded Rear television camera ground Always Below 1 Ω
a1-11 (LCV-) - a1-24 (LGND) W - BR Side television camera LH ground Always Below 1 Ω
a1-10 (LCV+) - a1-24 (LGND) R - BR Side television camera LH display signal input Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens not covered, displaying image Pulse generation (See waveform 1)
Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens covered, blacking out screen Pulse generation (See waveform 2)
a1-24 (LGND) - a2-3 (GND1) BR - BR Side television camera LH ground (shield) Always Below 1 Ω
a1-12 (LCB+) - a1-24 (LGND) B - BR Power source to side television camera LH Engine switch on (IG) 5.5 to 7.05 V
a1-14 (BCV-) - a1-27 (BGND) R - BR Front television camera ground Always Below 1 Ω
a1-13 (BCV+) - a1-27 (BGND) W - BR Front television camera display signal input Waveform 1: Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens not covered, displaying image Pulse generation (See waveform 1)
Waveform 2: Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens covered, blacking out screen Pulse generation (See waveform 2)
a1-27 (BGND) - a2-3 (GND1) BR - BR Front television camera ground (shield) Always Below 1 Ω
a1-15 (BCB+) - a1-27 (BGND) B - BR Power source to front television camera Engine switch on (IG) 5.5 to 7.05 V
a1-5 (RCV-) - a1-18 (RGND) R - BR Side television camera RH ground Always Below 1 Ω
a1-4 (RCV+) - a1-18 (RGND) W - BR Side television camera RH display signal input Waveform 1: Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens not covered, displaying image Pulse generation (See waveform 1)
Waveform 2: Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens covered, blacking out screen Pulse generation (See waveform 2)
a1-18 (RGND) - a2-3 (GND1) BR - BR Side television camera RH ground (shield) Always Below 1 Ω
a1-6 (RCB+) - a1-18 (RGND) B - BR Power source to side television camera RH Engine switch on (IG) 5.5 to 7.05 V


e.

Using an oscilloscope, check the waveform.

E254326C01
0.917,1.5 1.417,1.5 1.417,1.5 1.469,1.354 false 0.917,1.667 1.49,1.667 1.49,1.667 1.563,1.313 false 4.25,1.417 4.75,1.417 4.75,1.417 4.833,1.198 false 4.24,1.688 4.813,1.688 4.813,1.688 4.948,1.146 false 0.76,0.823 1.219,1.021 0.458,0.198 10 GND 4.031,0.823 4.49,1.021 0.458,0.198 10 GND 0.438,0.083 0.75,0.281 0.313,0.198 10 *a 3.771,0.083 4.083,0.281 0.313,0.198 10 *b 0.75,1.417 1.063,1.615 0.313,0.198 10 *c 0.75,1.604 1.031,1.76 0.281,0.156 10 *d 4.083,1.344 4.333,1.5 0.25,0.156 10 *c 4.073,1.625 4.292,1.771 0.219,0.146 10 *d
*a Waveform 1 *b Waveform 2
*c Synchronization Signal *d Video Waveform


i.

Waveform 1

Measurement Condition
Item Content
Terminal No. (Symbol)
·

a1-1 (CV+) - a1-9 (CGND)

·

a1-10 (LCV+) - a1-24 (LGND)

·

a1-13 (BCV+) - a1-27 (BGND)

·

a1-4 (RCV+) - a1-18 (RGND)


Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition
·

Waveform 1: Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens not covered, displaying image

·

Waveform 2: Engine switch on (IG), telltale light assembly (panoramic view monitor main switch) on, camera lens covered, blacking out screen



HINT:

The video waveform changes according to the image sent by the television camera assembly.






RADIO AND DISPLAY RECEIVER ASSEMBLY (w/ Audio and Visual System (for Radio and Display Type)


Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>TERMINALS OF ECU