Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) › from 2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0226195 LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) W

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM(w/ Steering Control)  CUSTOMIZE PARAMETERS  


CUSTOMIZE LANE DEPARTURE ALERT SYSTEM (w/ Steering Control)


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



HINT:

The following items can be customized.


a.

Customizing with the Multi-information display

i.

Turn the ignition switch to ON.


ii.

Enter the following menus: Settings Tab / Settings / Lane Departure Alert Setup


iii.

Select the setting by referring to the table below.


iv.

Change the settings of the lane departure alert using the steering pad switch assembly.

Lane Departure Alert
Display Content Setting Default
Steering Assist Steering assist function On/Off On
Warning Sensitivity Timing of lane departure warning High/Standard Standard
Vehicle Sway Warning Vehicle sway warning function On/Off On
Sway Sensitivity Vehicle sway detection sensitivity High/Standard/Low Standard