The ECM and driving support ECU assembly communicate signals with each sensor and ECU via CAN communication.
If there are any malfunctions in the communication circuit, one or more CAN communication system DTCs are output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Condition 1:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the ECM and the driving support ECU assembly is detected for approximately 0.92 seconds or more. Condition 2:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the ECM continuously receives a communication cut-off signal from the skid control ECU (brake actuator assembly) for approximately 0.15 seconds or more. |
Condition 1:
·
CAN communication system ·
ECM ·
Driving support ECU assembly ·
Network Gateway ECU Condition 2:
·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
| U0122 | Lost Communication with Vehicle Dynamics Control Module | When the ignition switch is turned ON and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and the ECM is detected for approximately 2.72 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
ECM |
| U0125 | Lost Communication with Yaw Rate Sensor Module | While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the yaw rate sensor and the driving support ECU assembly is detected for approximately 0.72 seconds or more. | ·
CAN communication system ·
Yaw rate sensor (airbag sensor assembly) ·
Driving support ECU assembly |
| U0126 | Lost Communication With Steering Angle Sensor Module | While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the steering angle sensor and the driving support ECU assembly is detected for approximately 5.04 seconds or more. | ·
CAN communication system ·
Steering angle sensor ·
Driving support ECU assembly |
| U0129 | Lost Communication with Brake System Control Module | While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and the driving support ECU assembly is detected for approximately 2 seconds or more. | ·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
Driving support ECU assembly |
| U0235 | Lost Communication with Cruise Control Front Distance Range Sensor | While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and the driving support ECU assembly is detected for approximately 1.6 seconds or more. | ·
CAN communication system ·
Millimeter wave radar sensor circuit ·
Millimeter wave radar sensor assembly ·
Driving support ECU assembly |
| U1104 | Lost Communication with Driving Support ECU | Condition 1:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the driving support ECU assembly and the millimeter wave radar sensor assembly is detected for approximately 0.92 seconds or more. Condition 2:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the driving support ECU assembly and ECM is detected for 0.144 seconds or more. |
Condition 1:
·
Millimeter wave radar sensor assembly ·
Driving support ECU assembly Condition 2:
·
CAN communication system ·
ECM ·
Driving support ECU assembly ·
Network Gateway ECU |
Refer to troubleshooting in CAN Communication System.
for LHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
for 2AD-FHV, 2AD-FTV:
for 2AR-FE, 3ZR-FE, 3ZR-FAE:
for 2WW:
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control switch (ON/OFF).
Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.
Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.
Check the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
for 2AD-FHV, 2AD-FTV:
for 2AR-FE, 3ZR-FE, 3ZR-FAE:
for 2WW:
| Result | Proceed to |
|---|---|
| DTC U0100, U0122, U0125, U0126, U0129, U0235 and U1104 are not output | A |
| DTC U0100, U0122, U0125, U0126, U0129, U0235 or U1104 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for LHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING