Home › Engine / Hybrid System › CRUISE CONTROL › FORWARD RECOGNITION CAMERA SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0226196 FORWARD RECOGNITION CAMERA SYSTEM C

CRUISE CONTROL  FORWARD RECOGNITION CAMERA SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0101  Lost Communication With TCM  U0123  Lost Communication with Yaw Rate Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  U0235  Lost Communication with Cruise Control Front Distance Range Sensor  U1104  Lost Communication with Driving Support ECU  


DESCRIPTION

These DTCs are output when a communication malfunction occurs between the sensors and ECUs.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" While the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the ECM and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

ECM

·

Forward recognition camera


U0101 Lost Communication With TCM While the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the ECM (TCM) and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

ECM

·

Forward recognition camera


U0123 Lost Communication with Yaw Rate Sensor Module While the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the yaw rate sensor and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Yaw rate and acceleration sensor (airbag sensor assembly)

·

Forward recognition camera


U0129 Lost Communication with Brake System Control Module While the ignition switch is ON, a communication error between the skid control ECU (brake actuator assembly) and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Skid control ECU (brake actuator assembly)

·

Forward recognition camera


U0142 Lost Communication with Body Control Module "B" 2 seconds after the engine switch is turned on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more.
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Forward recognition camera


U0235 Lost Communication with Cruise Control Front Distance Range Sensor 2 seconds after the engine switch is turned on (IG), a communication error between the millimeter wave radar sensor assembly and the forward recognition camera is detected for approximately 5 seconds.
·

CAN communication system

·

Millimeter wave radar sensor assembly

·

Forward recognition camera


U1104 Lost Communication with Driving Support ECU 2 seconds after the engine switch is turned on (IG), a communication error between the driving support ECU assembly and the forward recognition camera is detected for approximately 5 seconds.
·

CAN communication system

·

Driving support ECU assembly

·

Forward recognition camera



PROCEDURE

1.CHECK FOR DTCs
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.


e.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR

Chassis > Front Recognition Camera > Clear DTCs
50002 386

f.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



g.

Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.


h.

Check the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>DTC CHECK / CLEAR

Chassis > Front Recognition Camera > Trouble Codes
50001 386

Result:
Result Proceed to
DTC U0100, U0101, U0123, U0129, U0142, U0155, U0235 and U1104 are not output A
DTC U0100, U0101, U0123, U0129, U0142, U0155, U0235 or U1104 is output B



A

B